NETGEAR WN2000RPT - Universal WiFi Range Extender User Manual

16 | Chapter 2. Range Extender Network Settings
Universal WiFi Range Extender WN2000RPT
Status Screen
When you connect to http://www.mywifiext.net, after the automatic firmware check, the Status
screen displays. You can also select Status from the menu to display this screen:
This screen shows the current settings and the status of your range extender.
• You can click Show Statistics to see device performance statistics such as the number
of packets sent and number of packets received for each port. See Show Statistics on
page 18.
• The following table describes the fields in the Status screen.
Table 1. Status Settings
Field Description
Hardware Version The hardware version of the range extender.
Firmware Version The current firmware version of the range extender. If you
upgrade the firmware, this field changes.
GUI Language Version The language version running on the range extender. If
you upgrade the firmware, this field changes.
Connection Status to
Existing Network
Name (SSID) Your range extender is set up to connect to this SSID,
also called the wireless name.
Connection Status The status of your wireless connection (connected or
disconnected).
Link Rate The actual transmission (Tx) and receive (Rx) link rate in
the current wireless connection.

NETGEAR WN2000RPT - Universal WiFi Range Extender Specifications

General

Frequency Band	2.4 GHz
Ethernet Ports	1 x 10/100 Mbps
Security	WEP, WPA, WPA2
Wireless Speed	Up to 300 Mbps
Wireless Standard	802.11n
Antenna	Internal