NETGEAR WN2000RPTv2 Installation Guide

6
Connecting the Extender to an Existing
Wi-Fi Network
To extend the range of your Wi-Fi network, you will need to connect
the Extender to your existing Wi-Fi network. You have two options to
connect the Extender to your network.
Option 1: Connecting with WPS (Wi-Fi Protected Setup)
WPS lets you easily join a secure Wi-Fi network without typing
the network name and password. The WPS button is a physical
button on the Wi-Fi router, gateway, or access point.
If your router supports WPS (Wi-Fi Protected Setup ),
NETGEAR recommends that you use Option 1; otherwise, go to
Option 2.
Tip: WPS does not support WEP network security.
If you are using WEP security, use Option 2
to connect.
Option 2: Connecting without WPS, using web browser setup guide
The web browser setup guide walks you through the necessary
steps to connect your Extender to an existing Wi-Fi network.

NETGEAR WN2000RPTv2 Specifications

General

WiFi Technology	802.11n
Frequency Band	2.4GHz
Ethernet Ports	1 x 10/100 Mbps
Antenna	Internal
Wireless Speed	300 Mbps
Security	WEP, WPA, WPA2
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 95% non-condensing
LED Indicators	Ethernet
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)