NETGEAR WN3000RP Installation Guide

17
I enabled a wireless MAC filter (wireless access control or ACL)
on my router. What should I do when installing the extender?
When the wireless device connects through the extender to your
router, the MAC address of the wireless device shown on the router is
translated to another MAC address. If your router’s MAC filter is
enabled, the wireless device connects to the extender but cannot get
an IP address from the extender and cannot access the Internet.
To allow the wireless device to receive an IP address from the
extender and access the Internet, you must provide the translated
MAC address to the router.
1. Disable the MAC filter on your router.
2. Power on the extender and connect all of your wireless devices to
the extender.
3. Make sure that the Link Rate LED remains lit.
4. Log in to your router and check the attached devices on the
Attached Devices screen.
5. Add any MAC addresses that begin with 02:0F:B5 to your router’s
MAC filter table.

NETGEAR WN3000RP Specifications

General

Interface	Ethernet
Connectivity technology	Wireless
Wi-Fi band	Single-band (2.4 GHz)
Ethernet LAN	Yes
Security algorithms	WEP, WPA, WPA2-PSK
Networking standards	IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Maximum data transfer rate	300 Mbit/s
Chipset	-
Internal	No
Certification	RoHS, WEEE, CEC
Component for	PC/Laptop
Product color	White
Dimensions (WxDxH)	112 x 74 x 45 mm
Minimum system requirements	802.11 b/g/n 2.4 GHz wireless router or gateway 802.11 b/g/n 2.4 GHz wireless adapter or Ethernet adapter and cable for each computer
Compliance industry standards	IEEE 802.11 b/g/n
Compatible operating systems	Windows 7, Vista, XP, 2000 Mac OS UNIX Linux

Weight and Dimensions

Weight	245 g