3DHD Home Theater Adapter WNHD3004 User Manual
2-6 Setting Up Your Wireless Network
v1.0, November 2010
2. Connect the power adapter. The power light should blink in green.
3. On the new WNHD3004, press the WPS button; its WPS light will blink.Within 2 minutes,
press the WPS button on the existing Wireless-N Bridge which is operating in AP mode. Its
WPS light will start to blink.
After 1-2 minutes the new unit in Bridge mode should be associated with the existing unit in
AP mode. The WPS light for the AP unit and the Bridge mode unit will turn off. The power
lights on both units will be steadily on.
Figure 2-5
To Next Page
Loading...
