3DHD Home Theater Adapter WNHD3004 User Manual
4-8 Wireless Security
v1.0, November 2010
Push Button Configuration
There are two methods to enable a wireless client to join a network using a push button on the
router: using the physical push button or using the software button in the Add WPS Client screen.
Using the Physical Push Button
1. Press the button on the home theater adapter for over 5 seconds.
The blue button light begins to blink in a regular pattern. While the light is blinking, you
have 2 minutes to enable WPS on the client that you are trying to connect to the AP/Bridge.
2. On the wireless client, follow its specific networking instructions to enable WPS, to allow it to
connect to the router.
The home theater adapter’s blue button light ceases blinking and remains on when one of
these conditions occurs:
• The router and the client establish a wireless connection.
• The 2-minute window period expires for establishing a WPS connection. If the connection
is not established, no WPS security settings will be specified in the home theater adapter.
Using the Software Button in the Add WPS Client Screen
1. Log in to the router as described in “Connecting to the WNHD3004” on page 3-1.
2. Select Add WPS Client in the main menu, and click Next.
3. Select the Push Button setup method.
Figure 4-3
To Next Page
Loading...
