N300 Wireless Router with USB WNR2200 User Manual
USB Storage 7-1
v1.0, September 2010
Chapter 7
USB Storage
This chapter describes how to access and configure a USB storage drive attached to your router.
This chapter includes the following sections:
• “USB Drive Requirements”
• “File Sharing Scenarios” on page 7-2
• “ReadyShare Access” on page 7-10
• “USB Storage Basic Settings” on page 7-4
• “Configuring USB Storage Advanced Settings” on page 7-7
• “Unmounting a USB Drive” on page 7-10
• “Specifying Approved USB Devices” on page 7-11
• “Connecting to the USB Drive from a Remote Computer” on page 7-12
• “Connecting to the USB Drive with Microsoft Network Settings” on page 7-12
USB Drive Requirements
The router works with 1.0 and 1.1 (USB Full Speed) and 2.0 (USB High Speed) standards. The
approximate USB bus speeds are shown below.
Note: The USB port on the router can be used only to connect USB storage devices like
flash drives or hard drives. Do not connect computers, USB modems, printers, CD
drives, or DVD drives to the router USB port.
Bus Speed/Sec
USB 1.1 12 Mbits
USB 2.0 480 Mbits
To Next Page
Loading...
