N300 Wireless Router with USB WNR2200 User Manual
Safeguarding Your Network 2-20
v1.0, September 2010
• WPS Settings. For information about WPS settings, see “Using Push 'N' Connect (WPS) to
Configure Your Wireless Network” on page 2-12.
• Restricting access by MAC address. You can use a Wireless Card Access List to restrict
access. See “Restricting Access by MAC Address” on page 3-2.
Adding Guest Networks
Adding a guest network allows visitors at your home to use the Internet without having to know
your wireless security key. You can add a guest network to the wireless network.
To add a guest network, do the following:
1. Select Guest Network from the Setup menu. The Guest Network Settings screen appears
2. Select any of the following Wireless settings:
– Enable Guest Network – When this check box is selected, the guest network is enabled,
and guests can connect to your network using the SSID of this profile.
Figure 2-10
To Next Page
Loading...
