N300 Wireless Router with USB WNR2200 User Manual
Protecting Your Network 3-3
v1.0, September 2010
2. From the Advanced menu, select Wireless Settings, and then click Set Up Access List to
display the Wireless Card Access List screen.
3. Click Add to add a wireless device to the wireless access control list. The Wireless Card
Access Setup screen opens and displays a list of currently active wireless cards and their
Ethernet MAC addresses.
4. Adjust the list as needed for your network. You can add devices using either of the following
methods:
• If the computer is in the Available Wireless Cards table, select the radio button of that
computer to capture its MAC address.
Figure 3-1
Figure 3-2
To Next Page
Loading...
