NETGEAR XS716T - User Manual

Installation
ProSAFE Smart Managed Switch
XS708T and XS716T
XS716T
XS708T
Configure the Switch With a Static IP
Address
If you are using static IP addresses in your network, configure the switch
IP address before connecting the switch to your network. The default IP
address of the switch is 192.168.0.239.
Note: If your network uses a DHCP server, this section does not apply. Go
directly to Connect the Switch to a Network.
1. Configure a computer with a static IP address.
2. Plug the switch into a power outlet and connect your computer to the
switch using an Ethernet cable.
3. Open a web browser and enter the IP address of your switch.
The default IP address of the switch is 192.168.0.239.
A login page displays.
4. Enter password for the password.
5. Select System > Management > IP Configuration.
6. Enter the static IP address that you want to assign to the switch.
7. Click the Apply button.
Your settings are saved.
Connect the Switch to a Network
1. Connect each computer or device to an RJ-45 network port on the
switch front panel.
Use Category 5e (Cat 5e) or higher rated Ethernet cable (Cat 6, Cat 6a,
or Cat 7) terminated with an RJ-45 connector to make 10-Gigabit
connections.
Note: We recommend Cat 6a or Cat 7 cables if the cable distance is
greater than 45 m (148 ).
Package Contents
• NETGEAR ProSAFE Smart Managed Switch XS708T or XS716T
• Rubber footpads for tabletop installation
• AC power cord (localized to country of sale)
• 19-inch rack-mount kit for rack installation
• Resource CD
2. Connect the switch to your network.
3. Power on the switch.
Configure the Switch
You can configure the switch either by using a computer’s web browser or by
installing the Smart Control Center Utility on your Windows-based computer.
Web Browser Access
1. Connect the switch to your network.
2. For initial configuration, open a web browser on a computer that is on the
same network and subnet as the switch and enter the switch’s IP address.
If you are unsure how to determine the IP address of the switch, you can
use the Smart Control Center Utility.
3. Enter the password.
The default password is password.
4. Click the Login button.
5. Configure the switch for your network.
For information about switch configuration, see the soware administration
guide for your switch.
XS716T 10-Gigabit Ethernet
Smart Managed Switch
Server Workstation
ReadyDATA

NETGEAR XS716T Specifications

General

Brand	NETGEAR
Model	XS716T
Category	Switch
Language	English

Summary

Configure Switch Static IP Address

Static IP Configuration Process

Steps to assign a static IP address to the switch via a web browser, including IP assignment and saving settings.

Connect Switch to Network

Network Connection Steps

Guide on connecting devices, using appropriate cables for 10-Gigabit connections, and powering the switch.

Configure Switch Methods

Web Browser Access Configuration

Detailed steps for accessing and configuring the switch using a web browser, including login and network setup.

Smart Control Center Utility

Install SCC Utility

Instructions for installing the Smart Control Center Utility from the resource CD, requiring Adobe Air.

Configure Switch via SCC Utility

SCC Utility Configuration Steps

Steps to configure the switch using the SCC utility, including discovery, selection, and browser access.

Troubleshooting Tips

Common Setup and Connectivity Issues

Tips for resolving common problems, including power sequence, cable connections, and network settings.

Support Resources

Online Support and Documentation

Information on accessing NETGEAR support, product registration, downloads, manuals, and regulatory compliance.