ADSL2+ Modem Router User Manual
55
Phy port: the incoming port of the rule. It indicates the physical port of the traffic is
incoming.
Set Priority: the priority of the rule. It can be p0(highest), p1,p2,p3(lowest). The traffic
matches the rule will be assigned the priority you have configured.
Insert or modify QoS mark: you can insert or modify the DSCP or 802.1p tag. The traffic
matches the rule will be added or modified the mark.
Note:
If you select 802.1p tag, please make sure 802.1q is enabled in specified WAN interface,
otherwise 802.1p tag will not be tagged.
The QoS Rule list shows the current rules on the device.
Delete: select a rule then press “delete” button, the selected rule will be deleted from Qos
rule list.
Delete all: delete all the rules from QoS rule list.
(2) 802.1p
If the QoS policy is “802.1p based”, you should configure the 802.1p setting. Press the
“802.1p config” button to configure the 802.1p priority.
To Next Page
Loading...
Need help?
General
