Mode Button
Press the Mode button to switch between ‘Auto’ and ‘Continuous’
dehumidifying modes.
Auto Mode: When the ambient humidity is more than 3% over
the set humidity, the fan and compressor will start working. When
the ambient humidity is less than 3% over the set humidity, the
fan and compressor will stop working. The fan speed and
humidity setting can be adjusted under ‘Auto’ mode.
Continuous Mode: In this mode, the device will continue to run
on high fan speed and the default humidity setting is 20%. The
fan speed and humidity setting cannot be adjusted.
Sleep/Reset Button
Press the ‘Sleep/Reset’ button to activate ‘Sleep’ mode. Press
the button again to turn ‘Sleep’ mode off.
In ‘Sleep’ mode, the fan speed will be switched to low and after
10 seconds, all indicator lights and the display screen will be
switched off.
When the room humidity is less than 57%, the compressor and
the fan will stop working.
When the room humidity is more than 63%, the fan and
compressor will start working.
The fan speed setting function and humidity setting function
cannot be changed in this mode.
To Next Page
