In ‘Sleep’ mode, when the water tank is full, the machine will not
alarm but rather the water tank full indicator light will be on (red)
to remind you that the water tank is full and needs emptying.
Press and hold the ‘Sleep/Reset’ button for 3 seconds to reset
the air filter. When the machine has worked for 600 hours, the air
filter indicator light will turn on to remind you to clean the air filter.
The machine will not work until you clean and the air filter and
reset the unit.
Timer Button
Press the ‘Timer’ button to set the timer function (0-24H). Each
interval lasts 1 hour. Each time you press the ‘Add’ or ‘Minus’
buttons, the value increases or decreases by 1 hour respectively.
The corresponding timing value will be displayed on the screen.
When the device is on, set the timer function to countdown to
turn the device off. When the device is in stand-by mode, set the
timer function to countdown to turn the device on.
After the timer has been set, the timer indicator light will be on
during the timing period. When the timer finishes, the timer
indicator light will turn off.
To cancel the timer function, set the value to “00”. The indicator
light will turn off.
Fan Speed Button
Press this button to switch the fan speed between high and low.
The corresponding indicator light will be on. The fan speed can
only be adjusted in ‘auto’ mode.
To Next Page
