7,: normally we don’t advise clients to modify the printer Mac address, as that
"Mac Address" option “image 6.5” interface, because arp cache problem router
or computer can cause the system to wait after modifying the Mac
automatically refresh or that manually refresh arp after the cache in order to
properly connect the printer to the computer, to achieve a normal Ethernet
communication; under such special circumstances really need to modify the
Mac address, and recommends the following actions to manually refresh the
arp cache to achieve the fastest speed of the printer connected to the
computer, to achieve normal print. Modifying step is as follows:
1, on the “image 6.5” interface modification after pressing need of Mac "Save"
button to save the Mac address to achieve, and then shut down.
2,After two runs, while holding down the winkey + "run" R key or click the Start
menu and enter the following “image 6.6” interface as shown in “Image 6.7”
dos cmd into the environment.
Image 6.7 Run “cmd”
To Next Page
Loading...