Need help?Do you have a question about the Neumann TLM 102 and is the answer not in the manual?
Steps for attaching the microphone to a stand and using accessories.
Detailed instructions for connecting the microphone to audio equipment.
List of elastic suspensions and their catalog numbers.
List of auditorium hangers and their catalog numbers.
List of stand mounts and adapters with catalog numbers.
List of table and floor stands with catalog numbers.
List of foam windscreens and their catalog numbers.
List of popscreens and their catalog numbers.
List of power supplies and their catalog numbers.
List of connecting cables and their catalog numbers.
List of adapter cables and their catalog numbers.
General| Microphone Type | Condenser |
|---|---|
| Polar Pattern | Cardioid |
| Frequency Response | 20 Hz - 20 kHz |
| Max SPL | 144 dB |
| Sensitivity | 11 mV/Pa |
| Equivalent Noise Level | 12 dB-A |
| Impedance | 50 ohms |
| Acoustic Operating Principle | Pressure gradient transducer |
| Equivalent Noise Level, CCIR | 21 dB |
| Signal-to-Noise Ratio, CCIR | 73 dB |
| Signal-to-Noise Ratio, A-weighted | 82 dB |
| Current Consumption | 3.5 mA |
| Diameter | 52 mm |
| Length | 116 mm |
| Connector | XLR |
| Rated Load Impedance | 1 kOhms |
| Supply Voltage | 48 V |
To Next Page
