Need help?Do you have a question about the Neumann bcm 104 and is the answer not in the manual?
Describes the microphone's finish, connector, and pin assignments for balanced output.
Lists available microphone cables and their specifications for connection.
Explains the 48V phantom powering (P48, IEC 1938) and signal path.
Details using Neumann P48 power supply units like N 48 i-2 for operation.
Discusses connecting to unbalanced inputs and potential issues with phantom power.
Provides instructions for cleaning the microphone's headgrille.
Details how to remove and clean the integrated pop screen.
Advises against DIY repairs and recommends professional servicing for issues.
Describes swivel mounts for microphones with different thread sizes.
Describes replacement headgrilles for hygiene and personalization.
Details pop screens for vocal recordings and their mounting.
Describes foam windshields for reducing wind and plosive noise.
General| Type | Condenser |
|---|---|
| Acoustical operating principle | Pressure gradient |
| Polar Pattern | Cardioid |
| Frequency Response | 20 Hz - 20 kHz |
| Impedance | 50 ohms |
| Rated Impedance | 50 ohms |
| Rated load impedance | 1000 ohms |
| Supply voltage | 48 V |
| Power Supply | Phantom power |
| Connecting connector | XLR 3-pin |
To Next Page
