USER MANUAL
How to increase cutting speed
Decrease the torch-to-work distance. This will increase the negative cut angle.
Note: The torch must not touch the workpiece while piercing or cutting.
The thin lines are almost straight and at an angle of 15-30 degrees.
The cutting speed and Arc current is correct.
Lines are not straight and have a curved form in the upper part and further parts
directed vertically as shown in Figure.
The cutting speed is low. Increase the cutting speed.
Lines are not straight and have a curved form in the lower portion of the part as shown.
The cutting speed is too high or arc current is too low.
To Previous Page
Loading...