Neutec Studio Plus Series User Manual

MAN00080-01-EN
IMPORTANT:
Please read this handbook before using
the Neutec/USA® Studio™ Plus
Laser Welder
MIDI00SP
This device has been designed in compliance with IEC EN 61010-1 and IEC EN 60825-1 safety standards to prevent injury to the
operator if used correctly and properly. However, no engineering design can make this device safe if it is not used and maintained
properly and in compliance with safety standards. This manual should be read carefully and in its entirety before pe rforming any
operation. Failure to follow instructions and safety standards may cause injury to the operator and the device.

Neutec Studio Plus Series Specifications

General

Brand	Neutec
Model	Studio Plus Series
Category	Welding System
Language	English

Summary

Safety Information

General Safety Rules

Essential rules for safe operation and risk avoidance.

Specific Laser Hazards

Warnings about laser hazards, fumes, and fire risks.

Safeguards Overview

Danger Zones and General Rules

Device Specifications

Technical Specifications

Detailed technical characteristics and parameters of the device.

Electrical Connections and Power

Information on electrical hookup, power supply, and tolerances.

Intended Use

Defines the specific applications and materials for the device.

Improper Use and Labels

Improper Use Guidelines

Lists prohibited materials and actions when using the device.

Safety Labels Overview

Operator Interface

Controls and Indicators

Identifies and describes the device's front panel controls and displays.

Back Panel Connections

Use

Device Startup and Operation

Steps for turning on the device, emergency stop, PIN menu, and rotary use.

Maintenance

Regular Inspections

Coolant and Filter Management

Liquid Refill and Filter Maintenance

Checking and Correcting Alignment

Correcting Alignment and Repairs

Diagnostics

Error Codes and Troubleshooting

Explains error messages and provides solutions or service contacts.

Warning Messages and Causes