6
Press TIME
to recall the Aux time to the display. If other timers are in use, successive key presses will toggle
among them.
Press SET TIME
to enter the Aux Time setting mode. The control will prompt
[__SET__MM:SS_____]
Enter the Minutes and Seconds as needed. Press YES to accept the time entered.
NOTE:
Letters that have not been replaced with numbers will be replaced with zeros.
NOTE: Pressing NO will allow you to back up to make corrections or to abort without changing the time.
NOTE: To change the way the Aux Timer is configured, use the SET OPTIONS to first turn the Aux timer
off, then set it up again.
NOTE: Some options may not be available on all models and controls.
Press HOME SCORE
to enter the home score ADD mode.
The control might prompt
[__HOME_______2+__]
. In this example the current Home Score is
2 and the “+” indicates that the control is ready to add to the current score. Enter a single digit number or
press NO or YES or another function key to abort and leave the score unchanged.
NOTE: You cannot subtract from a score. To correct a mistake use the SET key, then the HOME or
GUEST SCORE key and directly enter the correct score (up to 99).
GUEST SCORE
works the same way.
Press TEAM AT BAT
to see the current status.
The control will show
[_____BATTING_____]
if neither team has started batting yet. Press the
TEAM AT BAT Key again to indicate
[_H___ BATTING ____]
and again to indicate
[_____BATTING ___G_]
.
NOTE: The first time the key is pressed, the current setting will be recalled to the display. Press any other
key to exit without changing the setting. To change the setting, first press the key to recall the current
setting to the display then toggle the setting with each additional key press. To clear both settings, press
SET, then TEAM AT BAT.
Press INNING
to enter the Inning ADD mode.
The control might prompt
[__INNING _____2+__]
. In this example the current Inning is 2 and
the “+” indicates that the control is ready to add to the current inning. Enter a single digit number or press
NO or YES or another function key to abort and leave the data unchanged.
NOTE: You cannot subtract, but you can use the SET key first, then directly enter the correct number (up
to 99).
Inning
Team
at
Bat
Home
Score
Guest
Score
Time
To Next Page
Loading...
