7
Press AT BAT to recall the player number
to the display on the control.
The control might display
[__AT BAT______12___]
. In this example the batters number is 12.
To change the number, simply enter the correct number, or press NO or YES or another function key to
abort and leave the data unchanged.
Note: Any number up to 99 may be entered.
Press BALL
to display the ball count and enter the ADD mode.
The control might display
[__BALL______1+___]
. In this example the current ball count is 1
and the “+” indicates that the control is ready to add to the current count. Enter a single digit number or
press NO or YES or another function key to abort and leave the data unchanged.
NOTE: You cannot subtract. To correct a mistake use the SET key, then the BALL key and directly enter
the correct count (up to 9).
STRIKE
works the same way.
OUT
works the same way except when the third out is added in, the Balls, Strikes, Outs, and At Bat are all cleared.
Press RESET
to clear the Balls, Strikes, and At Bat without affecting the Outs.
Press HIT
to toggle the hit indicator on or off.
The control will show
[__HIT__ ___ON__]
or
[__HIT_____OFF__]
.
NOTE: Each time the HIT Key is pressed, the status of the hit indicator changes.
ERROR
works the same way.
Hit
Error
Ball
Strike
Out
Reset
At
Bat
To Next Page
Loading...
