3
KEYBOARD FUNCTIONS
GREETING screen
When you are done using the control turn it OFF to conserve
batteries.
Note: In multiple controller setups. Verify that the second to last controller is
powered off before powering off the last controller so that the receiver gets the
power off command.
Note: Always power ON the receiver(s) (scoreboard(s)) first, and wait a few seconds for the receiver(s) to initialize
(red LED illuminates) before powering ON the control. If the control is already ON, turn it OFF, wait a few seconds,
and then turn it back ON.
Note: If the scoreboard fails to respond to the control, power the control OFF, wait a few seconds, and then try
again. Please allow time for each control to complete its powering ON process (main screen appears) before turning
ON another control.
GREETING
When the control is Powered ON, the greeting showing the
type of control, the software version, and the frequency it is
broadcasting. It will then display scanning for the remaining
time until the control establishes communications with its
receiver(s). (May take up to 20 seconds)
To Next Page
Loading...
