3. A short beep will sound when the Remote Control turns ON. The indicator
light above the word LINK will light up at this time.
Once the RC2000 Remote Control is ON, it will try to establish communication with
either the Trial Stimulator or the IPG. As it looks for these devices, the LINK indicator
light will blink and you will hear some beeps.
• If the RC2000 Remote Control establishes communication with either the Trial
Stimulator or the IPG, the LINK indicator light will stop blinking and remain
ON.
• If no communication is established, the RC2000 Remote Control will give three
short beeps and turn itself OFF.
How to Turn OFF the RC2000
The RC2000 Remote Control will automatically turn itself OFF if the Program Button is
not pressed for at least one minute.
You can verify that the Remote Control is OFF because the LINK indicator light will not
be ON or blinking.
How to Turn Therapy ON and OFF with the RC2000
Press the green Program Button. The light will come on indicating Program 1 or
Program 2. Keep pressing the button until the light is ON by the desired program.
Therapy with the selected program is ON.
Press the green Program Button until the lights by Program 1 and Program 2 are both
OFF. This means the Trial Stimulator or IPG is OFF and not delivering therapy.
RC2000 Indicator Lights
Use the table to help you interpret the lights on the RC2000 Remote Control.
To Next Page
