4 - OPERATING INSTRUCTIONS
(2) Enter the edit mode:
Turn the key switch to the “ON” position while pressing
the upper side of the Engine Speed Management (ESM)
main switch (1). At this time, the tire rolling circumference,
“CAL”,(2) and vehicle speed (3) will be displayed. (See
gure 5.)
NHIL20CT00112AA 4
(3) Changing the vehicle speed X km/h (X mph): Press
the upper side of the Engine Speed Management (ESM)
main switch (1) for approximately 1 s. The value of the
tire rolling circumference (2) and vehicle speed (3) will
change. The value change is only allowed before editing
the tire rolling circumference. (See gure 5.)
(4) Editing the tire rolling circumference: In the edit mode,
the rst digit will blink at rst. When pressing the up-
per side of the Engine Speed Management (ESM) speed
up/down switch (4), the next digit will blink. Then press the
lower side of the switch, the number is changed from”9” to
“0” each time you press the Engine Speed Management
(ESM) speed up/down switch (4).
(5) Press the upper side of the Engine Speed Manage-
ment (ESM) main switch (1) for over one second, and then
tire radius digits will blink 3 times indicating that your data
will be saved. If the lower side of the Engine Speed Man-
agement (ESM) main switch or the key switch to “OFF” or
“START”, your input data will not be saved.
NHIL20CT00096AA 5
4-6
To Next Page
Loading...
Need help?
General
