New Rock Technologies OM50 - 4.3 Configuring the IP Phones

www.newrocktech.com
4-33
4.3 Configuring the IP Phones
For New Rock NRP IP phone, the default configuration file is generated on the OM, and downloaded to
the phones through plug and play procedure described above. Other than achieving special features, there is no
need to configure the phone individually.
For a phone that is not a New Rock NRP phone, registration information must be entered. The
following describes the registration information using the NRP1012 as an example.
Step 1 Open the Web management interface of the IP phone, click VOIP > SIP, select the desired SIP
line, and then enter the registration information in Basic setting.
Item
Description
Server Address
Enter the IP address or dynamic domain name of the OM.
For Example : 192.168.111.41
Server port
Enter the SIP listening port of the OM. The default port is 5060.
Note: By default, the SIP listening port of the device and the SIP trunk share a
port, that is, port 5060. You can set a different registration port on the
Extension > IP> Registrar OPTIONS.
Authentication
User
Enter the number of the IP extension that is set in the OM. For example: 213.
Authentication
Password
Enter the password corresponding to the number of the extension. For
example: the password corresponding to the number 213 is 8240051.