EasyManua.ls Logo

Newco Bistro 10 User Manual

Newco Bistro 10
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Bistro 10
Operating Instruction Manual
Model B-10
1-800-325-7867
3650 NEW TOWN BLVD ST. CHARLES MO 63301
WWW.NEWCOCOFFEE.COM
Question and Answer IconNeed help?

Do you have a question about the Newco Bistro 10 and is the answer not in the manual?

Newco Bistro 10 Specifications

General IconGeneral
Dimensions15.25" H x 8" W x 11" D
Voltage120V
Capacity10 Cups
MaterialStainless Steel
Cord Length3 ft

Summary

Warning Labels

Introduction and Product Warranty

Product Introduction

Details the intended use and purpose of the coffee machine.

Newco Product Warranty Details

Outlines the terms, conditions, exclusions, and remedies of the warranty.

Machine Dimensions and Specifications

Machine Features

Plumber's Installation Instructions

Electrical Hook-Up

Guidance on connecting the machine to the electrical power source.

General Installation Instructions

Machine Setup Instructions

Product Installation Procedure

Drink Selection and Keypad Overview

Programming Mode Entry

Programming Mode Navigation

Maintenance Mode Functions

Details options within maintenance, including sanitation and seal status.

Statistics Mode Functions

Outlines how to view machine usage data and inventory levels.

Machine Setup Configuration

Setup Menu Options

Details key setup parameters like temperature, filter tracking, energy save, and service number.

Assigning Drink Recipes to Buttons

Configuring Service Contact Number

Machine Calibration Procedures

Mix Bowl and Auger Calibration

Details calibration for mix bowl volume and auger speeds for both chocolate and milk.

Coffee Calibration

Instructions for calibrating the coffee dispensing volume.

Editing and Creating Drink Recipes

Drink Recipe Parameters

Explains configurable options like volume, delay time, pump speed, and ingredient strength.

Daily Cleaning Procedures

Whipper System Disassembly

Beverage System Cleaning

Flushing Solution Setup

Cleaning Cycle Operation

Weekly Cleaning Instructions

Weekly Cleaning Procedures

Whipper System Maintenance

Lubrication

Guidance on lubricating the whipper motor shaft to minimize friction and extend component life.

Replacing Worn Components

Explains how to identify and replace worn seals and O-rings in the whipper system.

Seal and O-ring Replacement

Impeller Installation and Seizure Prevention

Service Notes and Troubleshooting

Draining the Hot Water Tank

Instructions for safely draining the hot water tank before maintenance.

Wiring Diagram

Related product manuals