XPS Motion Controller/Driver Quick Start
2.5.2 Ethernet Card Address Settings
In order to be able to communicate with the controller, you must set your Ethernet card
in the following way (this procedure is for the Windows XP operating system):
1. Start Button > Control Panel > Network Connections.
2. Right Click on Local Area Connection Icon and select Properties.
3. Highlight Internet Protocol (TCP/IP) and click on Properties.
4. Type the following IP address and Subnet Mask as shown in the next window.
5. Click “OK”.
7 EDH0205En1051 – 10/17
To Next Page
Loading...
