Main burner
Match Light
1. If the burner will not light after several attempts
then the burner can be match lit, before using the
match allow 5 minutes for any accumulated gas to
dissipate.
2. Clip a match on one end of the lighting rod.
3. Light match.
4. Hold lighting rod and insert lighted match right
next to the burner ports or ceramic file.
5. Push and turn the designated control knob to .
6. Burner should ignite immediately.
Component Identification
Note: Remove all packaging, including straps, before using the grill
Main Burners
Control Knob, Label
10
To Next Page
Loading...
