Nexo ID84

ACCESSORIES
ID84 Page 11 / 20
ACCESSORIES
WARNINGS
All ID84 / ID84L accessories are specifically rated in agreement with structural computations.
Never use other accessories – including push-pins – when assembling ID84 / ID84L cabinets than the ones provided by
NEXO: NEXO will decline responsibility over the entire ID84 accessory range if any component is purchased from different
supplier.
PROHIBITED: ID84/ID84L below ID84/ID84L or ID84/ID84L with IDS312 without dedicated accessory
IDU-BUMP
Lifting bracket for ID84 / ID84L, can be used with VNT-
LIFTADAPT or VNI-WMADAPT and VNI-WM200.
Up to 2x ID84 + 2x ID84L can be lifted.
IDT-PLADAPT
Pole stand accessory for ID84 to be use with 35mm pole.
Can be fixed to upper part or lower part of the ID84.
For 1x ID84.
IDU-COUPL
Coupling bracket for ID84
Up to2x ID84 + 2x ID84L can be coupled together
IDU-TCBRK84
Truss-clamp bracket for ID84, to attach one or multiple ID84 to a
truss, in horizontal or vertical arrangement.
1x TCBRK84 for a maximum of 2x ID84
2x TCBRK84 and additional hanging on IDU-COUPL for a
maximum of 2x ID84L + 2xID84
VNT-BP600
Base plate for ID84/ID84L/IDS312, footprint M20 for extended
bar.
IDT-BPADAPT must be used to secure ID84/ID84L/IDS312 to
the base plate
• 1x ID84L + 1x ID84
• 1x IDS312 + 1x ID84