EasyManua.ls Logo

Nexo NXAMP4x1mk2

Default Icon
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
DP4946-02a-DI
NXAMPMK2 POWERED TD CONTROLLER
NXAMP4x1MK2
NXAMP4x2MK2
NXAMP4x4MK2
USER MANUAL (LOAD5_28)

Table of Contents

Other manuals for Nexo NXAMP4x1mk2

Question and Answer IconNeed help?

Do you have a question about the Nexo NXAMP4x1mk2 and is the answer not in the manual?

Nexo NXAMP4x1mk2 Specifications

General IconGeneral
Channels4
Amplification TechnologyClass D
Sampling Rate96 kHz
Frequency Response20 Hz - 20 kHz
Frequency Response Accuracy+/- 0.5 dB
ProcessingDSP
Network ControlYes
Ethernet PortYes
GPIOYes
Mains Voltage100-240V
Voltage100-240V
Power per channel @ 2 Ohms1300W
Input Impedance20 kOhms
Latency1.5ms
THD+N<0.1%
THD0.05%
Dynamic Range>110dB
Signal to Noise Ratio110 dB
Input ConnectorsXLR
Output ConnectorsSpeakon
CoolingVariable speed fan
Dimensions88 x 483 x 450 mm

Summary

Safety Precautions and Handling

General Safety Instructions

Guidelines for safe operation, installation, and handling to prevent injury or damage.

Electrical and Fire Safety

Warnings about electrical hazards, proper power supply use, and water exposure.

Regulatory Compliance

NXAMPmk2 Panel Layout and Connections

Front Panel Description

Overview of front panel components like screen, encoder, and air intakes.

Back Panel Connections

Detailed description of all ports and connectors on the rear panel.

Power Output and Speaker Cabling

Explanation of SpeakON NL4 outputs and speaker connection configurations.

Audio Signal Management

Speaker Cabling and Output Modes

Guides on speaker cabling and output mode settings for various configurations.

Amplifier Operation and Settings

Startup and Menu Navigation

Initial amplifier startup procedure and introduction to the channel settings menu.

Header Menu and Shortcuts

Accessing the header menu, inactive view, lock, standby, and internal menus.

Speaker Preset Selection

How to choose and apply speaker presets via the interface.

Input Patching and Alignment

Configuring input patching and adjusting gain and delay for signal alignment.

Digital Audio Source and Volume

Selecting digital audio sources and adjusting output volume levels.

Detailed EQ Band Configuration

Interface for detailed EQ band adjustments including filter type, frequency, gain, and Q.

Scene Management

Saving and Recalling Scenes

Steps to save current amplifier settings as a user scene and load them later.

Remote Control and Network

Device ID and Network Settings

Configuring device ID, IP address, and netmask for remote network control.

Monitoring and Diagnostics

System Headroom and Load Monitoring

Understanding headroom, and configuring impedance monitoring for speaker connections.

Input Monitoring Setup

Configuring pilot tone detection for input signal presence and validity.

Advanced Settings and Configuration

Alerts and Error Handling

DPU Digital Patching Unit

NEXO NeMo Remote Control

Firmware Updates

Technical Specifications and Performance

Technical Specifications

Details on power output, audio characteristics, physical dimensions, and certifications.

Log and Alert Parameters

Related product manuals