Need help?Do you have a question about the Nexo CMS100 and is the answer not in the manual?
General| Brand | Nexo |
|---|---|
| Model | CMS100 |
| Category | Controller |
| Language | English |
Details controller features: display, sensors, and component control.
Explains controller display, LED indicators, and push button functions.
Presents diagrams and measurements of the controller's physical dimensions.
Provides instructions and diagrams for panel mounting the controller.
Details wiring diagram and connector layout for controller connections.
Explains how to access and replace the programming port cover.
Presents a detailed schematic of the controller's electrical connections.
Lists IEC and UL ratings for the controller's relays.
Specifies input ranges for appliance, condenser, and evaporator sensors.
Outlines environmental specifications: IP rating, operating temperature, and materials.
Describes types and installation procedures for temperature sensors.
Explains appliance sensor function: measures return air temperature for product temp.
Details mounting and function of the condenser sensor for refrigeration system monitoring.
Explains evaporator sensor's role in measuring evaporator temperature.
Describes door switch function, installation, alignment, and dimensions.
Details PIR motion sensor detection patterns, optimal placement, and mounting.
Lists available transformer options for powering the CMS100 controller.
Outlines the sequence of displays shown during controller startup.
Explains controller button functions for end-users and service engineers.
Describes controller firmware menus: Parameter list, Test routine, Faults, etc.
Illustrates the hierarchical structure and navigation of the controller's menu system.
Provides a step-by-step guide for accessing the controller's operational menus.
Explains how to perform various diagnostic tests on the controller's components.
Guides users on viewing and interpreting the last three recorded cooler fault codes.
Explains the process and purpose of performing a half reset on the controller's learning matrix.
Details how to access and interpret various operational statistics of the controller.
Explains the 'Limp home' functionality for maintaining cooler operation during faults.
Describes how the controller handles and indicates door open alarms, including buzzer.
Details how door alarms trigger 'Limp home' mode and the corresponding display indicators.
Explains how the controller manages and displays temperature sensor failures.
Describes 'Limp home' mode and controller actions for appliance sensor fault conditions.
Details 'Limp home' mode and controller behavior for refrigeration system failure (rSF) alarms.
Provides troubleshooting checks for Refrigeration System Failure (rSF) alarms.
Lists troubleshooting steps for Door Switch Broken Alarms.
Offers guidance for troubleshooting Door Broken Alarms.
Outlines checks for problems related to Appliance Sensor Alarms.
Provides troubleshooting steps for Condenser Sensor Alarms.
Explains potential causes and checks for Freeze-up protection (888) issues.
Lists checks for Condenser high temperature (Ht) alarm causes.
Addresses unexpected operational issues with lights, fan, and compressor.
Categorizes controller parameters by their primary function.
Explains the rules the controller uses for parameter value validation.
Provides detailed definitions, considerations, and ranges for controller parameters.
Lists product certifications and compliance standards (CE, UL, FCC, etc.).
Details Bluetooth certifications and regulatory approvals.
Explains common acronyms used throughout the manual.
Defines key terms related to the controller and its accessories for clarity.
To Next Page
