Nexo CMS100

CMS100 Product Manual, Issue 8
www.nexo.com Page 43
6. PARAMETERS
Operation parameters dene the alarms, self-learning, lights management, and also the delay to saving
and the saving temperature disable. The parameter values vary between dierent cooler types, cooler
characteristics, operating environments, brand requirements, and operational preferences.
Parameter settings are dened by customers and can be loaded and edited automatically, via the XML les,
or manually.
This section lists the full set of parameters relevant to the CMS100 controller, with their descriptions,
ranges and default values detailed for reference.
Firmware: Glass Door Cooler
6.1 Parameters by function
Temperature
Celsius or Fahrenheit (CF)
Set point (SP) and Dierential (dIF)
Saving set point (SSP), Saving dierential (Sd) and Saving temperature disable (PEr)
Appliance sensor: calibration 1 (CA1 )
Operation
Saving restart (Sr)
Delay to saving mode (dS )
Freeze-up protection (dtt )
Compressor rest time (rt )
Defrost
Defrost interval (dE) and Defrost duration (dd)
Defrost termination temperature (dtd)
Uninterrupted pull down (IPd)
Self-learning Learning period (LP) and activity frequency (AF)
Display Display (dIS ) and Display stability (d2)
Lights Light delay (Ld) and Marketing mode (Ar)
Evaporator fan
Fan set point (FSP)
Fan cycle on (FCO) and Fan cycle o (FCF)
Alarms
Alarm delay (Ad)
Buzzer enable (b0 ) and Buzzer duration (b1)
Refrigeration system failure (Ct )
Condenser high temperature (Ht )
Voltage
management
Supply high (HI)
Supply low (L0)
Stock sensing Shelf data enable (ShF)