DRIVING RECORDER PLAYER - OPERATION
26
How to use the Driving Recorder Player
Remove the SD Card from your iN-CAR CAM and insert it directly to the card reader on your PC,
alternatively connect the iN-CAR CAM to your PC using the supplied USB cable as described in
the Mass Storage section, on page 17.
Close any pop up messages and/or any media players which may automatically open when a SD
card or video files are detected.
Open the Driving Recorder Player software.
Import videos files to the Driving Recorder Player:
Located in the bottom left hand corner of the Driving Recorder Player window are the player controls,
click on the folder button. This will open a separate window which will allow you to browse your PC,
navigate to the SD card and it’s content, see image below.
Once you have located and highlighted the required folder, for example:
Removable Disk (D:) - DCIM - 10030101, press OK.
This will add the files within the selected folder to the ‘File List’ window of the Driving Recorder Player,
see item 10 on pages 24 and 25.
Playback:
Choose a video file to play, double click upon it to begin playback.
Once the file is playing, you can use the playback controls (8) for pause, forward, reverse as required.
Please stop playback before selecting another file.
Note:
- Playback via the USB Cable may result in playback jumping / freezing due to the transfer rate of
data, it is recommended that the files are viewed directly from your PC’s card reader - if you do not
have a card reader available, please copy files from the iN-CAR CAM to your PC and use these for
playback.
- Functions and operation of the driving Recorder Player may vary dependant on your PC’s
operating system.
- GPS data will only be displayed when a GPS signal was present during the recording.
- In event of loss of GPS signal the map will freeze until the GPS data is once more available.
Folder button
Navigate to the folder
containing the required
video files and press OK
To Next Page
Loading...