INSTALLATION (CONTD.)
Note:
- Your iNCAR-CAM is shipped with the Screen Saver function set to Default OFF. This is for ease of
initial setup.
Once setup is complete, the screen saver should be set to 10 seconds, in order to blank the screen
completely whilst driving. This avoids any potential distraction and may be a legal requirement in
some countries.
- It is recommended to position your iN-CAR CAM on the passenger side of the car, behind the rear
view mirror, as shown above. Whilst the camera needs to be located in a position within the wiper
swept area, do not allow the camera to obstruct your vision of the road ahead. Recommended
position is no more than 40mm within the wiper swept area.
- Do NOT mount the camera directly in front of the driver.
- Do not place the iN-CAR CAM in such a way that it may interfere with the deployment of air bags
or other safety equipment.
- Do not operate the unit while driving.
- To reduce the risk of theft, remove the unit and the mount from your vehicle, or position out of sight,
before leaving your vehicle unattended.
- In vehicles where the 12V / 24V output remains on when ignition is turned off please disconnect the
device when not in use.
- The supplied car adaptor has a 4m long cable to allow cable to placed neatly within the vehicle.
Make sure that the iN-CAR CAM power cable does not interfere with the drivers operating controls,
such as the steering wheel, pedals or gear levers.
- First time use of the device will require the Time and Date to be set. See Page 16 for details.
09
12-24V DC
The above diagram is for illustration purposes only.
To Next Page
Loading...
Need help?
General
