MASTERTRACE Appendix G MR100 for Windows CE
G.2
in the operation of MR100 for Windows CE, keyboard is needed to input the digital values for heater
setpoints and text characters for heater name.
3. How to start MR100 for Windows CE?
At production, QTERM-A7 is configured to automatically launch MR100 for Windows CE at boot
time. User can exit MR100 for Windows CE through the pull-up menu File/Exit or Close box. To run
MR100 for Windows CE again, (1) Go to HardDisk\MR100_for_Windows_CE* folder. (2) Double click the
executable file, MR100_for_Windows_CE*.exe.
4. MR100 for Windows CE Screen Structure
A typical MR100 screen is shown in Figure G.2. It consists of 3 major parts: (1) System pull-up
menu;(2)Function page;(3)Function page tap.
System pull-up menu provides accesses to all operation tasks such as file open/close, password
change, etc. Function page is MR100's primary working area. It displays all kinds of information which
MR100 gathers from each heat-tracing controller in the network. It also provides a graphical-user-interface
system for user to interface with controllers. Function page tap offers one-click access to all Function
pages.
Figure G.2 – System Setup Function Page
5. System Setup Function Page
System Setup Function Page, asshowninFigureG.2,isthefirstfunctionpageappearingonthe
screen immediately after the launch of MR100 for Windows CE. Later, it can also be opened by a click on
the System Setup tap.
There are 4 drop-down edit boxes and 1 data box on the System Setup Function Page.
To Next Page
Loading...