Nextron MASTERTRACE - Measured Values: Statistics Menu

MASTER TRACE
B.3
Appendix B Display Message
Details - Measured
MESSAGE NO: M1-12 APPLIES TO: Selected Heater
DEFAULT VALUE: N/A VALUE RANGE: 0 to 300 V
DISPLAY MODE: All RESTRICTIONS: Single-pole 1 and 2 point
modules
The displayed value is the measured supply voltage.
MESSAGE NO: M1-13 APPLIES TO: Selected Heater
DEFAULT VALUE: N/A VALUE RANGE: 0 to 1000 mA
DISPLAY MODE: All RESTRICTIONS: None
The displayed value is the ground leakage or ground fault current. If the current
exceeds the value range then “O.L.” is displayed.
Measured Values: Statistics Menu
MESSAGE NO: M2-01 APPLIES TO: Interface Module
DEFAULT VALUE: N/A VALUE RANGE: N/A
DISPLAY MODE: Advanced RESTRICTIONS: None
This message displays the name of the sub-menu when entered.
MESSAGE NO: M2-02 APPLIES TO: Interface Module
DEFAULT VALUE:Selected Htr VALUE RANGE: Set by MODULE RANGE
function
DISPLAY MODE: Advanced RESTRICTIONS: None
This function selects the heater circuit. Each heater circuit has a unique two-part
Heater Number. The first part is the Module Number and the second part is the
heater circuit within the Control Module. Press [VALUE ñ] or [VALUE ò] and
then press [STORE] to select a heater circuit. For convenience and to reduce
human error, the Heater Name is also displayed.
MESSAGE NO: M2-03 APPLIES TO: Selected Heater
DEFAULT VALUE: N/A VALUE RANGE: -50 to 500 °C
-58 to 932 °F
DISPLAY MODE: Advanced RESTRICTIONS: None
The displayed value is the lowest Heater Control Temperature since the last reset.
If the displayed value is “RTD SHORT”, a value less than the minimum range was
recorded. To reset the displayed value press [RESET]. To reset with all statistics
use RESET STATISTICS function.
MESSAGE NO: M2-04 APPLIES TO: Selected Heater
DEFAULT VALUE: N/A VALUE RANGE: -50 to 500 °C
-58 to 932 °F
DISPLAY MODE: Advanced RESTRICTIONS: None
The displayed value is the highest Heater Control Temperature since the last reset.
If the displayed value is “RTD OPEN”, a value greater than the maximum range
was recorded. To reset the displayed value press [RESET]. To reset with all
statistics use RESET STATISTICS function.
HEATER VOLTAGE
120V &
GROUND FAULT
CURRENT: 5mA &
MEASURED VALUES:
STATISTICS &
SELECT HT: 1-1 ?
NONAME &
MIN TEMPERATURE:
3°C &
MAX TEMPERATURE:
25°C &