2.6
MASTERTRACE Chapter 2 Getting Started
RESET
STATISTICS: YES?
"
Reset statistics for a new measurement interval. Data can be
read or cleared at any time to provide the most useful infor-
mation. MasterTrace™ will keep track of when the meas-
urement interval started. See Chapter 5: Operation and
Appendix B for a complete description of how data is gath-
ered and application ideas.
Important note:
If you clear statistics using an ML100, the statistics for all
heaters will be cleared. However, if you clear statistics us-
ing MR100, only the statistics of the selected heater is
cleared.
This completes setpoint programming and system testing.
Set the PROGRAM ENABLE dip switch to DISABLE to
prevent accidental setpoint changes or tampering. By fol-
lowing this sequence and message explanation it should be
fairly easy to install a similar control application. Refer to
Appendix A and Appendix B for further details.
As the system is used, some setpoints may need adjusting.
For example, frequent low temperature alarms might indi-
cate that the setpoint value was set too close to normal
heater temperature swings and needs to be lowered.
To Next Page
Loading...