8.4
MASTER
TRACE Chapter 8
Service & Testing
Before proceeding, check that all wires connected to the
module are correctly labeled. Check that the Programming
Sheet for Control Panel or Modules correctly reflects the
selected modules. Complete the following steps.
• Turn off power to the Interface Module.
• Disconnect power wires to the 12Vdc power supply.
• To replace the Programmed QTERM-A7 touch screen
terminal, remove the terminal from the panel enclosure,
then replaced with Nextron part number 9003-0062_1.
• To replace the Cable for QTERM-A7, remove the cable
by disconnecting all its wire connections, then replaced
with Nextron part number 9003-0063.
• To replace the 12Vdc power supply, remove the power
supply by disconnecting all its wire connections, then
replaced with Nextron part number 0507-0002.
To Next Page
Loading...