MASTER
TRACE
B.6
Appendix B
Display Message
Details - Measured
MESSAGE NO: M2-17 APPLIES TO: Selected Control Module
DEFAULT VALUE: N/A VALUE RANGE: 0 to 1,000,000 hours
DISPLAY MODE: Advanced RESTRICTIONS: None
The displayed value is the total time since power was first applied to the Interface
Module. It is useful for maintenance purposes. It cannot be reset.
MESSAGE NO: M2-18 APPLIES TO: Selected Control Module
DEFAULT VALUE: N/A VALUE RANGE: yes, no
DISPLAY MODE: Advanced RESTRICTIONS: None
This function resets all the statistical values except Total Run Time, Energy Used
Last Day and Energy Cost Last Day. Select “yes” and then press [STORE]. You
are asked to confirm your request. Again, select “yes” and then press [STORE].
The statistical values are now cleared. If the display interface is an ML100, this
function resets the statistical values of all the Control Module heaters. If the
display interface is an MR100, this function resets the statistical values of the
selected heater.
TOTAL RUN TIME:
20966 hrs &
RESET STATISTICS?
no ?
ARE YOU SURE?
no ?
To Next Page
Loading...