Need help?Do you have a question about the NF WF1943B and is the answer not in the manual?
General| Sweep | Linear, Logarithmic |
|---|---|
| Output Impedance | 50 Ω |
| Waveforms | Sine, Square, Pulse, Ramp, Noise, Arbitrary |
| Modulation | AM, FM, PM, FSK, PWM |
| Interface | USB |
| Output Voltage | 10 Vpp into 50Ω |
| Display | LCD |
| Power Supply | 100 to 240 VAC, 50/60 Hz |
Explains the importance of proper grounding to prevent electric shock.
Instruction to check power source voltage before connecting the equipment.
Warning about using correct fuses to prevent fire hazards.
Procedure to follow if smoke, odor, or noise is detected.
Warning about high internal voltages and the need for qualified service.
Details on connecting the power source, grounding requirements, and line filter.
General procedures for operating the WF1943B synthesizer.
Steps to initialize all settings to their default values.
Instructions for setting the output frequency using keypad or modify dial.
Procedures for setting the output amplitude using keypad or modify dial.
How to adjust the DC offset of the output waveform.
Method for setting the oscillation starting phase for burst and sweep.
Detailed explanation and operation of burst oscillation modes (Burst, Trigger, Gate, Triggered Gate).
Instructions for using single, continuous, and gated sweep modes with various parameters.
Configuration and operation of frequency (FM) and phase (PM) modulation.
How to create, edit, copy, and select arbitrary waveforms.
Information on error messages, their causes, and corrective actions.
Specific error messages related to power-on issues like memory loss or system test failures.
Error messages arising from incorrect operations or conflicting settings.
A table listing symptoms, possible causes, and corrections for suspected equipment failures.
Troubleshooting guide for common symptoms and their potential causes and corrections.
Procedures for testing the performance and accuracy of the synthesizer.
Method for measuring and judging the frequency accuracy of the output signal.
How to measure and evaluate the accuracy of the output amplitude for various waveforms.
Procedure for measuring and assessing the accuracy of the DC offset setting.
To Next Page
