Routing Maintenance
Rollerbrush
Device
R （Bｒｕｓｈ）
L（Bｒｕｓｈ）
18
Rolling Brush (Clean it regularly)
1. Turn over the host machine and press the
buckle on the main brush cover to take out
the roller brush.
2. Use the configured cleaning tool to clean
the dust outside the roller brush and inside
the roller brush cavity, and then remove the
entanglements on the roller brush.
3. Re-assemble the roller brush, and press the
main brush cover tightly to fix the buckle.
Buckle
1. Flip the machine, remove the screws and then
remove the edge brush.
2. Clean up the wound hair and dirt and pack
it back.
3. Correspond the left brush (L) and right brush
(R) to the letters L and R on the bottom shell,
and tighten the loading tool down.
Side Brush (Clean it regularly)
Note: Please replace the side brush every 3 to 6
months so as to ensure the good cleaning effect.
2-in-1 Electric-controlled Water Tank (Clean it every time)
1. Remove the rag and drain the water from
the tank.
2. Clean the dishcloth, dry the water tank and
dishcloth, and wait for next use.
Primary Filter
Foma Filter
HEPA
Dust Box
Water Tank
Mopping Bracket
Wiping Cloth
To Next Page