TOOLS for SMART MINDS
13
myDAQ control window contains the following elements:
1. Real-Time acquired value. It can be a voltage, current, or resistance value
according to the selected Measurement Type.
2. % FS. It represents the percentage with respect the full scale (range).
3. Measurement type. Use this button to select the type of measurement to be
performed. Supported values are:
a. Voltage DC
b. Voltage AC
c. Current DC
d. Current AC
e. Resistance.
4. Connection diagram. It shows the Banana Jack Connection to be used with the
selected Measurement Type.
5. Auto range. If enabled, range is automatically calculated by the DMM.
6. Manual range. Use these buttons to set the range of DMM. Range Values depends
on the Measurement type.
To Next Page
Loading...
