4.
Drill a hole at a suitable angle and with a diameter
of about 65 mm. Insert and adjust a plastic pipe.
5.
Prepare installation of the wall mounting.
6.
Install the wall mounting on the wall using suitable
screws. Ensure that the unit is properly mounted
on the wall to prevent noise and vibrations.
7.
When connecting cooling pipes to the right or left,
cut off the casing's groove.
8.
Cables for external sensors must enter on the right-
hand side. The condensation collection box is
equipped with outlet points with pipes on the
right-hand side and rubber plug on the left-hand
side.
AG-WT10Chapter 5 | Installation8
To Next Page
Loading...
