Transport
Take care when lifting and moving the indoor and
outdoor unit. We recommend that you ask for assist-
ance and bend your knees when you lift to avoid injur-
ing your back. There is a risk of cutting yourself on the
sharp edges of the climate unit.
Assembly
We recommend that this climate unit be installed by
an authorised technician in accordance with the sup-
plied installation instructions.
NOTE
■
Do not install this climate unit where there
are flue gases, flammable gases or a lot of
moisture, e.g. in a greenhouse.
■
Do not install this climate unit where there
is equipment that generates too much heat.
■
Do not install the unit in premises where it
may be subjected to water splashes (e.g.
laundry rooms).
■
To protect the climate unit from corrosion,
the unit must not be installed where it can
be directly exposed to seawater splashes or
sulphur fumes.
Selection of installation location for indoor
unit
Caution
For optimum comfort, energy saving and
function the unit should be positioned as re-
commended below.
Prevent the following:
■
Proximity to heat sources that can damage the unit's
cover.
■
The presence of oil vapour (such as in a kitchen or
near industrial machinery) because oil contamination
can lead to malfunction or deform surfaces, especially
the unit's plastic surfaces.
■
Premises with unstable surfaces can cause vibrations,
noise or water leaks.
■
To drill holes in enclosed areas where there are elec-
trical parts or units.
The following is recommended:
■
Select the appropriate position from which every
angle of the premises can be heated uniformly.
■
Check that the surface is sufficiently stable to carry
the weight of the unit.
■
Select a suitable position to ensure good ventilation
and maintenance space around the unit.
Installation area
Minimum working and maintenance range (measured
in mm):
NOTE
Ensure that all pipes and hoses are insulated
to prevent the build-up of condensation.
Supplied components
AG-WT10-7:AG-WT10-4:
1 x Remote control1 x Remote control
2 x Battery2 x Battery
1 x Flared nut 1/4"1 x Flared nut 1/4"
1 x Flared nut 1/2"1 x Flared nut 3/8"
AG-WT10Chapter 2 | Delivery and handling4
2 Delivery and handling
To Next Page
Loading...
