Nibe FLM - Page 14

is still visible and a menu called “alarm” is visible in the display, the
problem causing the alarm still remains. If the alarm initially disappears
and then returns, you should contact your installer.
aid mode “aid mode” is a type of emergency mode. This means that
the heat pump produces heat and/or hot water even if there is some
kind of problem with the heat pump. This could mean that the heat
pump’s compressor is not in operation. In this case, the immersion
heater produces heat and/or hot water.
Problems withNIBE FLM do not affect heat pump operation. You do not
need to select "aid mode" in event of problems with NIBE FLM.
Caution
Selecting "aid mode” is not the same as correcting the problem
that caused the alarm. The status lamp will therefore continue
to be red.
If the alarm does not reset, contact your installer for suitable remedial
action.
NOTE
You need the product's (14 digit) serial number for servicing
and support.
NIBE FLMChapter 3 | Disturbances in comfort14