Nibe FLM - Glossary

ADDITIONAL HEAT
The additional heat is the heat produced in addition to the heat supplied
by the compressor in your heat pump. Additional heaters can be for ex-
ample, immersion heater, electric heater, gas/oil/pellet/wood burner or
district heating.
BRINE
Anti-freeze liquid, e.g. ethanol or glycol mixed with water, which trans-
ports heat energy from the heat source (rock/ground/lake) to the heat
pump.
BRINE SIDE
Brine hoses, any bore holes and the evaporator make up the brine side.
CIRCULATION PUMP
Pump that circulates liquid in a pipe system.
CLIMATE SYSTEM
The climate system can also be called the heating and/or cooling system.
The building is cooled or heated using radiators, under floor coils or
convector fans.
DISTURBANCES IN COMFORT
Disturbances in comfort are undesirable changes to the hot water/indoor
comfort, for example when the temperature of the hot water is too low
or if the indoor temperature is not at the desired level.
A malfunction in the heat pump can sometimes be noticed in the form
of a disturbance in comfort.
In most cases, the heat pump notes operational interference and indicates
this with alarms and shows instructions in the display.
NIBE FLMChapter 5 | Glossary18
5 Glossary