13NIBE PB 10
Installation
Description of functions
Description of functions
If the burner is connected electrically, turn the thermostat
down, switch on the main switch.
Note how the two uppermost LEDs flash (the burner's limit
position switch must be pressed in).
One LED indicates the read off potentiometer and the
other indicates the set value. Now look at the inside of
the cover. The table found there shows how many flashes
correspond to a certain value. The most important value to
you as an installer is the firing supply (P2).
It controls the supplied output in the burner, the higher the
output, the more flashes, the lower the output the fewer
flashes.
The function of the LEDs
LED LD3 (green) indicates the potentiometer that will be
shown.
LED LD2 (yellow) flashes the amount of times that the po-
tentiometer is set at.
LED LD1 (red) comes on when the photocell registers light.
Flashes occur regardless of whether the burner is in opera-
tion or not.
Look at the table on the inside of the cover, to determine
the time for just that potentiometer.
LD1 P3
P5
P4
P2P1LD2LD3
To Next Page
Loading...