Nibe PB 10 - Electrical Connection PB 10 to PELLUX 200 _ 15; Electrical Connection PB10; Electrical Connection PELLUX 200

15NIBE PB 10
Installation
Electrical connection of PB 10 to PELLUX 200
Installing PB 10 on PELLUX 200
Electrical connection PB10
• Connect the black wire to terminal 1 in the plug.
• Connect the brown wire to terminal 2.
• Connect the blue wire to terminal N.
• Connect the earth wire to earth in the plug.
Electrical connection PELLUX 200
• Connect the burner cable’s black wire to
plinth 11 terminal 3
• Connect the blue wire to plinth 11 terminal 2
• Connect the brown wire to plinth 11 terminal 1
• Take the switch supplied with the burner.
• Connect the burner cable’s black wire to terminal 1 in
the plug socket.
• Connect the brown wire to terminal 2.
• Connect the blue wire to terminal N.
• Connect the earth wire to earth in the plug socket.
Hang the burner on the swing
arm and slide it into place.
Secure the burner using the
screw knobs.
LEK
11