25NIBE PB 10
Miscellaneous
4. Pull off and turn the joint pipe. Slide the drive section
and the joint pipe so that the end with socket is at the
end of the screw. Slide the drive section and joint pipe
until they bottom. Turn the joint pipe so that the socket
in the joint pipe is on the opposite side (180 degrees) as
the drive section's outlet.
5. Use the supplied drill to make a hole straight through
the joint sleeve and joint pipe and tighten using the
supplied screw.
6. Connect to a 220/230 V power source and test run.
1. Remove the plastic panel that covers the motor section
(drive section).
2. Remove the end panel from the pipe without the motor
(joint pipe).
3. Remove the strap that holds the drive section and the
joint pipe, bend out the joint pipe. Take care as the coil
is tensioned.
Installation of NIBE pellet screw 2.5m
Accessories
To Next Page
Loading...