Nibe PCM 40 - Pressure Drop Analysis; Electrical Connection Safety Notes

Pressure drop diagram
PCM 40 brine side
0,1 0,150,050 0,2 0,25 0,3 0,40,35
16
14
12
10
8
6
4
2
0
18
0,50,45
Flöde, l/s
Kyla
Värme
Tryckfall (kPa)
kPa
Cooling
Heating
Flow l/s
PCM 40 heating medium side
Flöde, l/s
Värme
Tryckfall (kPa)
0,1 0,150,050 0,2 0,25 0,3 0,40,35
4
3
2
1
0
kPa
Heating
Flow l/s
PCM 42 brine side
0,1 0,2 0,3 0,4 0,5 0,6 0,7 0,8 0,9 0,100
18
16
14
12
10
8
6
4
2
0
20
22
Värme
Kyla
Flöde, l/s
Tryckfall (kPa)
kPa
Cooling
Heating
Flow l/s
PCM 42 heating medium side
kPa
Flow l/s
Värme
Flöde, l/s
Tryckfall (kPa)
16
14
12
10
8
6
4
2
0
18
20
0,1 0,2 0,3 0,4 0,5 0,6 0,7 0,80
Heating
Electrical connection
NOTE
All electrical connections must be carried out
by an authorised electrician.
Electrical installation and wiring must be carried
out in accordance with the stipulations in force.
The main product must be disconnected from
the power supply when installing PCM 40/42.
NOTE
If the supply cable is damaged, only NIBE, its
service representative or similar authorised
person may replace it to prevent any danger
and damage.
NOTE
To prevent interference in the event of any spli-
cing, communication and/or sensor cables to
external connections must not be laid closer
than 20 cm from high voltage cables.
The electrical circuit diagrams are at the end of this In-
staller Manual.
PCM 40/42 | GB22