Nibe S1156 - Included Supplied Components; Handling and Removing Panels

Supplied components
O-rings
8 x
Room
sensor(BT50)
1 x
Outdoor temperat-
ure sensor (BT1)
1 x
LEK
Aluminium tape
1 x
LEK
Level vessel (CM2)
1 x
Temperature
sensor
3 x
Filterball (QZ2)
8 kW
1 x G1
1 x G3/4
13 kW
1 x G1
1 x G1 1/4
LEK
Cold water shut-
off and expansion
relief valve,
water heater (FL1)
1 x
LEK
Insulation tape
1 x
Label for external
control voltage for
the control system
1 x
Compression ring
couplings
8 kW
2 x (ø28 x G25)
3 x (ø22 x G20)
13 kW
5 x (ø28 x G25)
LOCATION
The kit of supplied items is placed in packaging on top of
the heat pump.
Handling panels
OPEN FRONT HATCH
Press the hatch's top left corner to open it.
REMOVE THE FRONT
1. Remove the screw in the hole next to the on/off button
(SF1).
2. Pull the panel's top edge towards you and lift diagonally
upwards to remove it from the frame.
UN
NIBE S1156Chapter 2 | Delivery and handling8