Nibe SPLIT ACVM 270 - Table of Contents

For Home Owners
General
3
Installation data
3
Information about the installation
Product information 4
Features of NIBE SPLIT
4
Principle of operation NIBE SPLIT
4
Front panel, indoor module
How to use the front panel 6
Menu types
6
Quick movement
6
Key lock
6
Comfort setting heating
General 7
Operating status
7
Changing the room temperature manually
7
Default setting
8
Readjusting the default settings
9
Comfort setting cooling
General 10
Cooling operated from the outdoor sensor in operating
mode AutoK
10
Controlling cooling mode using the room sensor
10
Comfort setting hot water
Available volume (ACVM 270 with AMS 10-8) 11
Available volume (ACVM 270 with AMS 10-12)
11
Prioritizing
11
Extra Hot Water
11
Maintenance
Checking the safety valves in ACVM 270 12
Pressure gauge in ACVM 270
12
Emptying the hot water heater
12
Emptying the vessel
12
Maintenance of AMS 10
12
Saving tips
12
Dealing with comfort disruption
Operating mode "Add. heat only" 14
Emergency mode
14
Alarm indications
What happens in the event of an alarm? 15
Recommended actions
15
Acknowledging alarms
15
For the Installer
General information for the installer
Transport and storage 16
Supplied components
16
Assembly
16
Dimensioning expansion vessel
17
Manual shunting
17
Emptying the vessel
17
Recommended installation order
17
Pipe installation
General 18
System requirements
18
Dimensions and pipe connections
18
Pump capacity diagram
18
Connecting the climate system
18
Connecting the hot water heater
19
Connection of external heat source
19
Waste exchanger part
19
Connecting refrigerant pipes (not supplied)
19
Dockings
22
Electrical installation
General 27
Electrical components
27
Connecting the supply
28
Miniature circuit-breaker
28
Temperature limiter
28
Connection between ACVM 270 and AMS 10
28
Setting max power, electrical addition
29
Setting max boiler temperature
29
EBV board, terminal and wiring diagram
29
Connecting the outside sensor
29
Connecting the current limiter
29
Connection of centralised load control/tariff
30
Connecting external contacts
30
Alarm outputs
30
Docking specific connection
30
Start-up and inspection
Preparations 32
Commissioning
32
Setting system flow heating
32
Setting system flow cooling
32
Commissioning ACVM 270 without AMS 10
33
Checking external addition with internal immersion heater
blocked
33
Checking external addition (not controlled by ACVM 270)
with internal immersion heater as backup
33
Inspection of the installation
33
Cleaning the particle filter
33
Secondary adjustment
33
Checklist: Checks before commissioning
34
Miscellaneous
Control
Display 35
Menu types
35
Menu management
35
Menu tree
36
Main menus
44
1.0 [N] Hot water temp.
45
2.0 [N] Supply temp.
46
3.0 [N] Supply temp. 2
47
4.0 [N] Outdoor temp.
48
5.0 [N] Heat pump
48
1NIBE™ SPLIT
Table of Contents